Gadsden Electrician Pros, AL
Electrical Wiring & Repair, Lighting, Generators & Panel Upgrades
Gadsden Electrician Pros is a licensed and insured electrician serving Gadsden, AL and the towns around it. We handle electrical repair and wiring, lighting and ceiling fan installation, whole house generators and panel upgrades, with EV charger circuits and whole-home surge protection under the panel work. Emergency calls and commercial jobs across Etowah County round out the list.
Every job starts with a free estimate, whether you're in town or out in Attalla or Glencoe, and we clean up before we leave.
Contact Us
Electrical Repair & Wiring
Census survey data shows about seven in ten homes in the Gadsden City School District area were built before 1970. That age shows up as two-prong outlets, too few circuits for a modern kitchen, and connections that have loosened over decades. Our electrical repair and wiring work covers the faults and the upgrades:
- Outlets and switches: dead, warm or sparking outlets, new outlets and 240-volt outlets for dryers, ranges and EV chargers
- GFCI protection: kitchens, bathrooms, garages and outdoor outlets, where the electrical code calls for it
- Smoke and CO detectors: hardwired detectors installed or replaced
- Dedicated circuits: for appliances, workshops and outbuildings
- Inspections and rewiring: checks on older wiring, through to rewiring part or all of a house
GFCIs shut the power off automatically when current leaks to ground. The Electrical Safety Foundation (ESFI) reports a 95% drop in electrocutions caused by consumer electronics since they were introduced, and we can add them where an older room lacks them. Homes built between 1965 and the mid-1970s may also have aluminum branch wiring, which the US Consumer Product Safety Commission (CPSC) links to overheating at the connections. We look for it when inspecting a house from that era.
Lighting & Ceiling Fan Installation
We handle lighting installation inside and out: recessed lights cut into existing ceilings, new fixtures and chandeliers, under-cabinet and porch lighting, LED retrofits, and ceiling fans. Swapping a fan where wiring is already in place is the simpler job; a fan in a room that has never had one needs a fan-rated box and usually a new switch run, which we price on the free estimate.
Outdoor outlets go on GFCI protection. In older properties, from houses built before 1970 to the downtown historic district along Broad Street, the existing boxes and switch wiring are worth checking before anything new goes in.
Whole House Generators
NWS Birmingham describes two severe weather seasons in Alabama, one in spring and one in fall, and November is the state's third most active tornado month after April and March. Etowah County has seen the damage: straight-line winds brought trees down onto homes in and around Gadsden in April 2008, and an EF-3 tornado touched down east of Sardis City in April 2014. A standby generator starts on its own when the grid drops and, depending on the size of the unit, can keep the fridge, well pump, heating or AC and medical equipment running.
We size the unit to what you need to run, fit the transfer switch and connect it to your panel. More on sizing, fuel and costs is on our page about whole house generator installation.
Portable generator safety: never plug a portable generator into a wall outlet or wire it straight to the panel. Power fed back into the lines can seriously injure or kill utility workers, so a transfer switch or interlock is needed. Run a portable unit outside only, at least 20 feet from the house, and never in a garage, basement or shed. CPSC puts the average at about 100 deaths a year in the US from carbon monoxide from portable generators.
Electrical Panel Upgrades, EV Chargers & Surge Protection
If your home still runs on 100-amp service, a move to 200 amps usually gives room for central air, an electric range, a water heater and an EV charger on the same panel (a load calculation confirms it). A panel upgrade is also the time to add arc-fault (AFCI) breakers, which shut a circuit off when they detect dangerous arcing; CPSC estimates AFCIs could prevent more than half of the electrical fires that occur each year.
We also replace single breakers, add subpanels for garages and additions, and look at older Federal Pacific and Zinsco panels on request. On Federal Pacific, CPSC closed its 1983 investigation saying its data did not establish a serious risk, and announced no recall, so we judge each panel on its condition rather than its brand alone.
- EV charger installation: a Level 2 charger runs on 240 volts and needs its own circuit; local permits may apply.
- Whole-home surge protection: a surge device at the panel covers every circuit, where a power strip covers only what is plugged into it. ESFI notes most surges start inside the house, for example when an air conditioner kicks on, so a house that runs AC all summer has its own regular source of surges. Alabama also logged more than 2.3 million lightning flashes in 2025, 10th among states for lightning density.
Emergency Electrician
Burning smells, sparking outlets, switch plates that are hot to the touch, and a breaker that keeps tripping are warning signs that need a licensed electrician promptly. If you smell burning, turn off the main breaker if you can do it safely. If you see smoke or flames, get everyone out and call 911. CPSC advises against simply resetting a breaker over and over, because a trip often means the circuit is overloaded. Dim or flickering lights are an early warning sign too.
If the whole street is dark, the fault is probably the utility's. Alabama Power customers can report or check an outage online, by texting "out" or "status" to APCOUT (272688), or on 1-800-888-2726. Parts of Etowah County are served by Cherokee Electric Cooperative or Marshall-DeKalb Electric Cooperative instead. If the neighbors have power and you don't, call us.
Commercial Electrical Work
We take on electrical work for shops, offices and small commercial buildings: outlet installation and repair, LED lighting upgrades, subpanels, and the wiring for build-outs and office renovations. Much of downtown's older building stock sits in the historic district along Broad Street, where the existing wiring is worth checking before a new tenant's equipment goes on it.
Electricians for Attalla, Rainbow City, Southside & Glencoe
Gadsden sits on the Coosa River, which runs through the center of town, with I-759 linking it to Interstate 59. We work across the city and in the towns around it:
- Attalla, west of Gadsden, where US 11 and I-59 pass through
- Rainbow City, running from the Gadsden city line on its north to the Coosa on its east, with US 411 (Rainbow Drive) through its center
- Southside, on the south side of the Coosa and partly in Calhoun County, with City Hall on Highway 77
- Glencoe, in southern Etowah and northern Calhoun counties, cut through by US 431
Southside and Glencoe each sit partly in Calhoun County, so give us the full address when you call.
Typical Electrical Prices in 2026
An electrical panel upgrade typically costs $500 to $4,500 in 2026, and a whole house standby generator $5,000 to $20,000 installed, depending on the job. These are typical published prices around Gadsden, mostly from national cost guides as Alabama figures are thin, not ours: your free estimate is the real number for your job.
Bigger jobs, installed
- Electrical panel upgrade or replacement $500–$4,500
- 100-amp to 200-amp upgrade (most jobs) $1,300–$3,000
- Whole house standby generator $5,000–$20,000
- Whole-house rewiring, average home $7,000–$30,000
Smaller jobs
- Level 2 EV charger installation, labor $400–$1,200
- Whole-home surge protector $70–$700
- Ceiling fan on existing wiring $100–$400
- GFCI outlet, each $130–$300
Jobs that need new wiring or a panel upgrade cost more, such as an EV charger that needs a bigger panel, a ceiling fan where there's no wiring yet, or outdoor GFCI outlets. Rewiring works out at about $3 to $15 per sq ft. Your free estimate gives the real price for your home.
Typical published prices, mostly from national cost guides as Alabama figures are thin, checked October 2026. Not a quote.
Licensed and Insured in Alabama
Alabama law says no one may run an electrical contracting business or work as a master or journeyman electrician without a license, apart from a few listed exemptions. Anyone can check a license on the Alabama Electrical Contractors Board's public Licensee Search.
We're licensed and insured, and we'd encourage you to check any company before you hire it for electrical services. Alabama has no statewide electrical code for homes: the state's adopted code, the 2020 National Electrical Code, applies to state buildings, schools and hotels, so permits and inspections for a house are set locally.
Frequently Asked Questions
Quick answers on licensing, estimates, outages and older Gadsden homes.
Are you licensed and insured?
Yes. You can confirm any Alabama electrical license on the Alabama Electrical Contractors Board's Licensee Search.
Do you give free estimates?
Yes. We look at the job, explain what's needed and give you a free, no-obligation estimate before any work starts.
Which areas do you cover?
Gadsden and nearby towns, including Attalla, Rainbow City, Southside and Glencoe.
My power is out. Should I call you or the utility?
If your neighbors are out too, report it to your utility first: Alabama Power, or Cherokee Electric or Marshall-DeKalb Electric in parts of the county. If only your home or one part of it has lost power, call us, and if the fault turns out to be on the utility's side, we'll tell you.
Does an older home need an electrical inspection?
ESFI recommends one for any home 40 or more years old, and for homes 10 or more years old that have had a major renovation, an addition or a large new appliance. With about 70% of homes in the Gadsden City School District area built before 1970, many qualify.
Why does my breaker keep tripping?
Often because the circuit is overloaded, though a short, a ground fault or a worn breaker can do it too. Don't keep resetting it; call us to find the cause.
Can I do my own electrical work in Alabama?
State licensing law exempts a property owner doing electrical work on their own premises, but it says nothing about permits, and local rules still apply. Check with your city before you start.
